AGS 2+ GEL – Graffiti Remover For Porous

AGS 2+ is a powerful graffiti and paint remover. For use on exterior and interior surfaces. AGS 2+ may be used on porous surfaces for all weather conditions. Readily

AGS 2+ GEL is a thickened highly effective graffiti remover to be used on both porous and hard surfaces.
AGS 2+ GEL dissolves spray-paint graffiti, permanent markers and even petroleum based rust protective sealers.
AGS 2+ GEL may be used on following surfaces:

Porous surfaces
Concrete, brick, granite, marble, limestone, sandstone, slate, surfaces painted with non-organic paint.

Hard surfaces
Metal, treated wood, clinker, glazed brick, glass.

                               

INSTRUCTIONS FOR USE
Graffiti-removal
Apply AGS 2+ GEL with a brush or airless sprayer. Agitate the surface well. Leave until graffiti has dissolved, 20 minutes – 4 hours. When cold, the time increases. Jet off with hot water and high pressure, (90°C, 150 bar/2175 PSI). Lance nozzle spread should be 15 – 25 degrees and water flow should be 15 to 20 litres/minute, (4-5 gal/minute).
 

Note!
For metal surfaces do not use to high pressure.
Instead wipe with sponge or cloth and rinse with warm water.

Dosage
Use as concentrate.

Consumption:
0,5 – 1,0 ltr/mē.

Precautions:
Protective clothing. Visor when hight-pressure washing and breathing mask in poorly ventilated areas.

Tecnical data:
• Viscous bluish fluid.
• Supplied in 5 or 25 ltrs plastic jerricans.
• Mild odour.
• Contains: Gamma-Butyrolacton, mixture of Aliphatic, Naphtenic and aromatic
hydrocarbons.
• MSDS.  AGS 2+ENG  Biodegradability of AGS 2+

Storage:
Store frost-free in original closed container.

Shelf life:

Approximately 24 months in un opened container.

Marking
Not classified as dangerous goods in ADR or IMDG.

*This product information is intended as a guide for use of this product. TRION TENSID AB cannot give any guarantee for end result achieved. Applicator of product shall carry out testing and be responsible for the result.